Sec-1037; Sec-1038; Sec-1040; Sec-1041 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

75

SEC-1037

SEC-1037
Message
<timestamp>, [SEC-1037], <sequence-number>,, ERROR, <system-name>, Invalid WWN
format
Probable Cause Indicates the world wide name (WWN) entered in the policy member list had an invalid format.
Recommended Run the command again using the standard WWN format, 16 hexadecimal digits grouped as eight
Action colon separated pairs. For example: 50:06:04:81:D6:F3:45:42.
Severity ERROR

SEC-1038

Message
<timestamp>, [SEC-1038], <sequence-number>,, ERROR, <system-name>, Invalid domain
<domain ID>
Probable Cause Indicates an invalid domain ID was entered.
Recommended Verify that the domain ID is correct. If it is not, then re-run the command using the correct domain
Action ID.
Severity ERROR

SEC-1040

Message
<timestamp>, [SEC-1040], <sequence-number>,, ERROR, <system-name>, Invalid
portlist (
Probable Cause Indicates the port list contains the wildcard asterisk (*) character. You cannot use the asterisk in a
port list.
Recommended Enter the port list values without any wildcards.
Action
Severity ERROR

SEC-1041

Message
<timestamp>, [SEC-1041], <sequence-number>,, ERROR, <system-name>, Invalid port
member <port member> in portlist (<port list>). <Reason>.
Probable Cause Indicates the port member is invalid for one of the following reasons:
•
•
•
Recommended Use valid syntax when entering port members.
Action
416
<invalid WWN>
.
.
<port list>
). Cannot combine * with port member in the same portlist.
The value is not a number.
The value is too long. Valid numbers must be between one and three characters long.
The value cannot be parsed due to invalid characters.
Fabric OS Message Reference
53-1001157-01