Zone-1002; Zone-1003; Zone-1004; Zone System Messages - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

ZONE System Messages

ZONE-1002

Message
<timestamp>, [ZONE-1002], <sequence-number>,, WARNING, <system-name>, WWN
zoneTypeCheck or zoneGroupCheck warning(<warning string>) at port(<port number>).
Probable Cause Indicates a zone filter or zone group check failure occurred. The frame filter logic reported a failure
when creating or adding zone groups during port login (PLOGI) trap processing. This messages
usually indicates problems when adding content-addressable memory (CAM) entries before the
filter setup.
Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
Action supportSave command and contact your switch service provider.
Severity WARNING

ZONE-1003

Message
<timestamp>, [ZONE-1003], <sequence-number>,, WARNING, <system-name>,
zone(<current zone>) contains (<domain id>, <port number>) which does not exist.
Probable Cause Indicates the port zone member that is targeted for the local switch contains a non-existent port.
The effective zoning configuration (displayed in the error message) contains a port number that is
out of range.
Recommended Edit the zone database and change the port number to a viable value in the effective configuration.
Action
Severity WARNING

ZONE-1004

Message
<timestamp>, [ZONE-1004], <sequence-number>,, INFO, <system-name>, port <port
number> (<port number (hex)>) enforcement changed to Session Based HARD Zoning.
Probable Cause Indicates the zoning enforcement changed to session-based hard zoning. When a device is zoned
using both world wide name (WWN) in one zone and <domain, portarea> in another, this will cause
that port to go to session-based hard zoning.
Fabric OS Message Reference
53-1001157-01
Chapter
92
529