Ficu-1007; Ficu-1008; Ficu-1009 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

Recommended Check if the FICON channel corresponding to the PID in the message is functioning correctly.
Action
Severity WARNING

FICU-1007

Message
<timestamp>, [FICU-1007], <sequence-number>,, WARNING, <system-name>, <function
name>: Failed to allocate memory while performing <message>.
Probable Cause Indicates that memory resources are low. This might be a transient problem.
Recommended If the message persists, check the memory usage on the switch, using the memShow command.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING

FICU-1008

Message
<timestamp>, [FICU-1008], <sequence-number>,, WARNING, <system-name>, FMS mode
has been enabled. Ports:<port numbers> have been disabled due to port address
conflict.
Probable Cause Indicates that the specified ports were disabled when Fibre Connectivity (FICON) Management
Server mode (fmsMode) was enabled. This is due to a port address conflict or the port address
being reserved for the CUP management port.
Recommended No action is required.
Action
Severity WARNING

FICU-1009

Message
<timestamp>, [FICU-1009], <sequence-number>,, WARNING, <system-name>, FMS Mode
enable failed due to insufficient frame filtering resources on some ports.
Probable Cause Indicates that the frame filtering resources required to enable Fibre Connectivity (FICON)
Management Server mode (fmsMode) were not available on some of the ports.
Recommended Use the perfDelFilterMonitor command to delete the filter-based performance monitors used on all
Action ports to free up the resources.
Severity WARNING
Fabric OS Message Reference
53-1001157-01
29
FICU-1007
207