Pdm-1001; Pdm-1002; Pdm-1003; Pdm System Messages - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

PDM System Messages

PDM-1001

Message
<timestamp>, [PDM-1001], <sequence-number>,, WARNING, <system-name>, Failed to
parse the pdm config.
Probable Cause Indicates the parity data manager (PDM) process could not parse the configuration file. This might
be caused by a missing configuration file during the installation.
Recommended Run the firmwareDownload command to reinstall the firmware.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING

PDM-1002

Message
<timestamp>, [PDM-1002], <sequence-number>,, WARNING, <system-name>, ipcInit
failed.
Probable Cause Indicates the parity data manager (PDM) process could not initialize the inter-process
communication (IPC) mechanism.
Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
Action supportSave command and contact your switch service provider.
Severity WARNING

PDM-1003

Message
<timestamp>, [PDM-1003], <sequence-number>,, WARNING, <system-name>, pdm [-d] -S
<service> -s <instance>.
Probable Cause Indicates a syntax error occurred when trying to launch the parity data manager (PDM) process.
Recommended Run the firmwareDownload command to reinstall the firmware.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
Fabric OS Message Reference
53-1001157-01
Chapter
61
369