Ficn-1041; Ficn-1042; Ficn-1043; Ficn-1044 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

28

FICN-1041

FICN-1041
Message
<timestamp>, [FICN-1041], <sequence-number>,, ERROR, <system-name>,
HostTapeEgr:AS Link Level Reject (LRJ) from CU Rx Path=<FICON PATH>
LastCmd=0x<Last 4 commands issued to this device from the channel>
LastStatus=0x<Last 4 status values sent to the channel from this device>.
Probable Cause Indicates an LRJ received from a device indicates that the CU has lost the logical path to the LPAR.
Recommended If this was an unexpected event, contact your vendor's customer support for assistance.
Action
Severity ERROR

FICN-1042

Message
<timestamp>, [FICN-1042], <sequence-number>,, WARNING, <system-name>,
HostTapeIng:FICON Cancel received Path=<FICON PATH> state=0x<the current
emulation state for this device>.
Probable Cause Indicates a job was cancelled during a write pipelining.
Recommended If this was an unexpected event (cancel is normally an operator event), contact your vendor's
Action customer support for assistance.
Severity WARNING

FICN-1043

Message
<timestamp>, [FICN-1043], <sequence-number>,, ERROR, <system-name>,
HostTapeIng::FICON Selective Reset:Path=<FICON PATH> state=0x<the current
emulation state for this device> LastCmds=0x<the last 4 commands received from the
channel for this device> LastStatus=0x<the last 4 status values presented to the
channel for this device>.
Probable Cause Indicates that protocol errors in emulation in the CU or network errors can cause a Selective Reset.
Recommended If this was an unexpected event, contact your vendor's customer support for assistance.
Action
Severity ERROR

FICN-1044

Message
<timestamp>, [FICN-1044], <sequence-number>,, ERROR, <system-name>,
HostTapeIng:FICON Selective Reset:Path=<FICON PATH> Elapsed Time=<the number of
seconds since the last IO started for this device>.<the number of milliseconds
since the last IO started for this device> seconds.
Probable Cause Indicates that protocol errors in emulation in the CU or network errors can cause Selective Reset.
192 Fabric OS Message Reference
53-1001157-01