Em-1061; Em-1062; Em-1063; Em-1064 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

Severity WARNING

EM-1061

Message
<timestamp>, [EM-1061], <sequence-number>,, WARNING, <system-name>,
Synchronization halted. Remove all blades of type
your standby CP, then reboot or run haSyncStart.
Probable Cause Indicates a blade in the system is not supported by the release on the standby control processor
(CP).
Recommended Remove all blades of this type or upgrade your standby CP. Once an appropriate action is taken,
Action this CP must be rebooted or haSyncStart must be run successfully. Until this is done, the system
will remain out of synchronization.
Severity WARNING

EM-1062

Message
<timestamp>, [EM-1062], <sequence-number>,, CRITICAL, <system-name>, Blade in
slot <Slot Id> faulted as it exceeds the maximum support limit of <Limit> blades
with Blade ID <Blade Type Id> in the chassis.
Probable Cause Indicates too many blades of a particular type are in the system.
Recommended Remove the faulted blade.
Action
Severity CRITICAL

EM-1063

Message
<timestamp>, [EM-1063], <sequence-number>,, CRITICAL, <system-name>, Blade in
slot <Slot Id> faulted because it exceeds the maximum support limit of <Limit>
blades with Blade IDs <Applicable blade Type IDs> in the chassis.
Probable Cause Indicates too many blades of a set of particular types are in the system.
Recommended Remove the faulted blade.
Action
Severity CRITICAL

EM-1064

Message
<timestamp>, [EM-1064], <sequence-number>,, CRITICAL, <system-name>, Blade:<slot
ID> is being powered off (based on user configuration) upon receiving a HW ASIC
ERROR, reason:<Fault reason>.
Fabric OS Message Reference
53-1001157-01
EM-1061
<Blade Type Id>
or upgrade
17
119