Fw-1011; Fw-1012; Fw-1033; Fw-1034 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

35

FW-1011

Recommended Verify that you have installed the power supply correctly and that it is correctly seated in the
Action chassis. If the problem persists, replace the faulty power supply.
Severity WARNING
FW-1011
Message
<timestamp>, [FW-1011], <sequence-number>,, INFO, <system-name>, <Label>, is
above high boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.
Probable Cause Indicates that the power supply is functioning properly.
Recommended Set the high boundary above the normal operation range.
Action
Severity INFO

FW-1012

Message
<timestamp>, [FW-1012], <sequence-number>,, INFO, <system-name>, <Label>, is
between high and low boundaries(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the power supply counter changed from a value outside of the acceptable range to a
value within the acceptable range.
Recommended No action is required. Respond to this message as is appropriate to the particular policy of the
Action end-user installation.
Severity INFO

FW-1033

Message
<timestamp>, [FW-1033], <sequence-number>,, INFO, <system-name>, <Label>, value
has changed(High=<High value>, Low=<Low value>). Current value is <Value> <Unit>.
Probable Cause Indicates that the temperature of the small form-factor pluggable (SFP) has changed. Frequent
fluctuations in SFP temperature might indicate a deteriorating SFP.
Recommended No action is required. Respond to this message as is appropriate to the particular policy of the
Action end-user installation.
Severity INFO

FW-1034

Message
<timestamp>, [FW-1034], <sequence-number>,, WARNING, <system-name>, <Label>, is
below low boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.
224 Fabric OS Message Reference
53-1001157-01