Configure Snmp Trap Message Recipients; Add Preferred Path Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Installing and Configuring the Edge Switch 2/24
3. Click Add. The Add Preferred Path dialog box displays
Figure 21: Add Preferred Path dialog box
4. At the Source Port field, type a value between 0 through 23. For this switch,
5. At the Exit Port field, type a value between 0 through 23. For
6. At the Destination Domain ID field, type a value between 1 through 31. This
7. Click OK to close the Add Preferred Path dialog box and add the path to the
8. Repeat
9. At the Configure Preferred Paths dialog box, select (click) the Enable
10. Click Activate to enable all configured preferred paths and close the dialog

Configure SNMP Trap Message Recipients

Perform this procedure to configure community names, write authorizations, and
network addresses and for up to 12 SNMP trap message recipients on the HAFM
appliance. A trap recipient is a management workstation that receives notification
(through SNMP) if a switch event occurs.
76
the value uniquely identifies the starting port for the preferred path.
this switch, the value uniquely identifies the exit port for the preferred path.
value uniquely identifies the destination director or switch in the path.
list at the Configure Preferred Paths dialog box.
step 3 through
Preferred Path check box.
box.
step 7 to configure additional preferred paths.
(Figure 21).
Edge Switch 2/24 Installation Guide