Configure Snmp Trap Message Recipients - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Installing and Configuring the Edge Switch 2/24
4. Update the address resolution protocol (ARP) table for the browser PC.
a. Choose File >Exit to close the embedded web server and browser
applications. The Windows desktop displays.
b. Choose Start > Programs > Command Prompt. A disk operating system
(DOS) window displays.
c. Delete the switch's old IP address from the ARP table. At the command
(C:\) prompt, type arp -d xxx.xxx.xxx.xxx, where
xxx.xxx.xxx.xxx is the old IP address for the switch.
d. Click close (X) at the upper right corner of the DOS window to close the
window or enter exit at the prompt to return to the Windows desktop.
5. At the PC, launch the browser application (Netscape Navigator or Internet
Explorer).
6. At the browser, enter the switch's new IP address as the Internet URL. The
Username and Password Required dialog box displays.
7. Type the default user name and password.
NOTE: The default user name is Administrator and the default password is password. The
user name and password are case-sensitive.
8. Click OK. The embedded web server interface opens with the View window
displayed.

Configure SNMP Trap Message Recipients

Perform this procedure to configure community names, write authorizations, and
network addresses and for up to 6 SNMP trap message recipients. A trap recipient is a
management workstation that receives notification (through SNMP) if a switch event
occurs.
To configure SNMP trap recipients:
1. Choose Configure at the left side of the window. The Configure window opens
with the Ports tab displayed.
2. At the Configure window, click the Management tab. The Management page
displays with SNMP tab selected, as shown in
2-18
Figure 2–10.
edge switch 2/24 installation guide