Table of Contents
Advertisement
Appendix C. Service Processor Setup and Test
Attention:
This procedure applies to modems attached to the serial ports (S1, S2, and S3) on the
IntelliStation POWER 9114 Model 275 systems.
For your convenience, an example of a basic service processor setup checklist is included here. Your
setup may include more or fewer of the available features, so you can adjust this checklist for your own
application.
Service Processor Setup Checklist
1. Unplug the power cord from the system.
2. Attach a local terminal for this setup procedure.
3. Plug in the system and power on the local terminal.
Note: Make sure that system power remains off.
4. Start the service processor menus. See Chapter 7, "Using the Service Processor," on page 193.
5. Set the system name. See "Privileged User Menus" on page 195.
6. Enable surveillance. See "Service Processor System Monitoring - Surveillance" on page 222.
7. Configure Call-In/Call-Out. See "Call-In/Call-Out Setup Menu" on page 211.
8. Exit the service processor menus.
9. Unplug the power cord from the system.
10. Attach modems (if needed). See "Accessing the Service Processor Menus Remotely" on page 193.
11. Plug in the system.
Note: Make sure that system power remains off.
12. Test the following:
v Call-In, see "Testing Call-In" on page 316
v Call-Out, see "Testing Call-Out" on page 316
13. Use the "Save or Restore Hardware Management Policies," in the "Introduction to Tasks and Service
Aids" section of the RS/6000 Eserver pSeries Diagnostic Information for Multiple Bus Systems to
back up the service processor settings.
Note: This step is strongly recommended to protect the usefulness of the service processor and the
availability of the system.
Your service processor is now ready for use.
315
Advertisement
Table of Contents
