Table of Contents
Advertisement
1 PCI Adapter Dividers (Long)
2 PCI Adapter Dividers (Short)
3 System in Service Position
Replacing a PCI Adapter Divider
To replace an adapter divider, do the following:
1. If you are replacing a long PCI adapter divider that should contain light pipes, do the following:
a. Identify the correct slots for the light pipes on the long PCI adapter divider.
b. Carefully place the light pipes into the correct slots of the long PCI adapter divider.
2. Locate the PCI adapter divider slot you want to use.
3. Carefully grasp the adapter divider by its top edge, and align the adapter divider with the grooves at
the front and rear of the system.
4. Press the adapter divider into place.
5. If necessary, replace the PCI adapter cards as described in "Replacing or Installing a
Non-Hot-Pluggable PCI Adapter" on page 255.
6. If you are replacing or installing a short adapter divider, continue to the next step. If you are replacing
or installing a long adapter, do the following:
a. Close and latch the PCI adapter light-pipe plate attached to the fan tray.
b. Note the guide grooves located toward the front of the system in the disk drive backplane, and
align the adapter divider correctly.
7. Reconnect the power source to the system.
8. Replace the service access cover as described in "Replacing the Service Access Cover" on page
249..
9. Return the system to the operating position as described in "Placing the Model 275 into the Service
and Operating Position" on page 248.
10. Start the system as described in "Starting the System" on page 247.
258
IntelliStation POWER 9114 Model 275 Service Guide
5
4
1
2
3
4 Fan Tray Light-Pipe Plate
5 Light Pipes
Advertisement
Table of Contents
