Table of Contents
Advertisement
Serial Port Configuration
To configure the serial port on an AIX system, run the following from an AIX console:
1. Log in as root user.
2. To determine if you have any serial ports already configured, type the following:
lsdev -Cc tty
If no serial ports are configured, nothing will be listed. If you want to configure serial ports that are not
listed, continue with the remaining steps.
3. Identify the serial port(s) with the modem(s).
4. Type smit tty.
5. Select add tty.
6. Select RS232.
7. Select Baud rate 9600 or higher.
8. Select login enable and set the flow control to RTS.
9. Commit the selections and set up any other needed serial ports.
10. Exit SMIT.
Appendix C. Service Processor Setup and Test
317
Advertisement
Table of Contents
