Scsi Ids And Bay Locations - IBM 9114-275 - IntelliStation POWER 275 Service Manual

SCSI IDs and Bay Locations

The following figure shows the SCSI bay locations for the Model 275.
Index
1
2
3
4
5
6
7
8
Notes:
1. The SCSI bus IDs are the recommended values and indicate how the IDs are set when the system is
shipped from the factory. Field installations might not comply with these recommendations.
2. One disk drive backplane is standard in the Model 275. In the figure above, the system is shown fully
populated with one backplane and four disk drives.
3. Media bay location Index 2 is designed to house one of the following optional devices:
v IDE Optical Drive
v Diskette Drive
Any SCSI device used in media bay location Index 4 must be connected to a PCI SCSI adapter.
16
IntelliStation POWER 9114 Model 275 Service Guide
Drive Name
Operator Panel
Diskette Drive
or IDE Optical Drive
IDE DVD-ROM (Default)
Tape Drive (Optional)
SCSI DVD-RAM (Optional)
Disk Drive 1
Disk Drive 2
Disk Drive 3
Disk Drive 4
SCSI ID
(U0.1-P1-X1/Q6-A1, for optical drive)
IDE (Non-SCSI)
(U0.1-P1-X1/Q6-A0)
SCSI ID 0
SCSI ID 1
SCSI Bus 0 SCSI ID 3
SCSI ID 4
SCSI ID 5
SCSI ID 8