Table of Contents
Advertisement
Service Processor Error Codes
Attention:
Follow the procedure defined in the "Checkpoint and Error Code Index" on page 134. If you
replace FRUs or perform an action and the problem is still not corrected, go to "MAP 1548: System
Processor Problem Isolation" on page 90 unless otherwise indicated in the tables.
If you replace FRUs and the problem is corrected, go to "MAP 0410: Repair Checkout" in the RS/6000
Eserver pSeries Diagnostic Information for Multiple Bus Systems.
Table 6. Service Processor Error Codes.
Error Code Description
406x 0002 System unit backplane fault
406x 0003 Scan interface basic assurance tests detected
processor fault
406x 000E Processor capacity card
406x 0010 Memory DIMM fault
406x 0011 Memory DIMM fault
406x 0012 Memory DIMM fault
406x 0013 Memory DIMM fault
406x 0014 Memory DIMM fault
406x 0015 Memory DIMM fault
406x 0016 Memory DIMM fault
406x 0017 Memory DIMM fault
406x 00B7 Insufficient hardware resources were detected to
continue IPL of the system after processor sub
system testing and initialization was completed.
406x 00D1 Informational message
406x 0100 Memory quad A failure
406x 0101 Memory quad B failure
Action/
Possible Failing FRU
System unit backplane
Location: U0.1-P1
System unit backplane
Location: U0.1-P1
Operator panel
Location: U0.1-L1
Memory DIMM
Location: U0.1-P1-M5
Memory DIMM
Location: U0.1-P1-M7
Memory DIMM
Location: U0.1-P1-M4
Memory DIMM
Location: U0.1-P1-M2
Memory DIMM
Location: U0.1-P1-M6
Memory DIMM
Location: U0.1-P1-M8
Memory DIMM
Location: U0.1-P1-M3
Memory DIMM
Location: U0.1-P1-M1
Go to "MAP 1540: Problem Isolation Procedures"
on page 87
Informational message
Go to "MAP 1240: Memory Problem Resolution"
on page 55
Go to "MAP 1240: Memory Problem Resolution"
on page 55
Chapter 5. Error Code to FRU Index
163
Advertisement
Table of Contents
