IBM 9114-275 - IntelliStation POWER 275 Service Manual page 135

Table 2. Firmware Checkpoints (continued)
Checkpoint
E1A2
E1A3
E1A4
E1A5
E1A6
E1A7
E1A8
E1A9
E1AA
E1AB
E1AC
E1AD
E1AE
E1AF
E1B1
E1B2
E1B3
Description
User requested boot using default service
mode boot list via keyboard entry
User requested boot using customized
service mode boot list via keyboard entry
User requested boot to SMS menus CSP
command
User requested boot to open firmware
prompt CSP command
User requested boot using default service
mode boot list via CSP command
User requested boot using customized
service mode boot list via CSP command
System booting to open firmware prompt
System booting to SMS menus
System NVRAM settings during boot
System booting using default service mode
boot list
System booting using customized service
mode boot list
System booting to operating system
System booted to multiboot menu via
NVRAM settings
System booted to utilities menu via NVRAM
settings
Create serial node
XOFF received - waiting for XON
XON received
Action/
Possible Failing FRU
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
Go to "MAP 1540: Problem Isolation
Procedures" on page 87.
There may be a hardware problem with the
service processor in the managed system.
Check the service action event log in
Service Focal Point for error codes that
indicate a problem with the serial ports on
the service processor. (The service
processor is at location U0.1-P1-X1.) Take
the appropriate actions based on the error
codes that are found.
This checkpoint will flash by too quickly to
be seen on the operator panel. It may be
recorded in the progress indicators log,
which is accessed using the service
processor menus.
If a partition hangs on this checkpoint:
1. Check for platform firmware updates.
Apply if available.
2. Call service support.
Chapter 4. Checkpoints
117