Table of Contents
Advertisement
Replacing the Network Adapter
If a network adapter is replaced, the network administrator must be notified so that the client IP addresses
used by the system can be updated. In addition, the operating system configuration of the network
controller may need to be changed in order to enable system startup. Also check to ensure that any client
or server that accesses this system is updated.
Determining Location Code
If you have an error code in the form 2xxx xxxx or Exxx, and no location code associated with it, the
location code may possibly be found in three places, depending on the state of the system:
v For systems with AIX installed: if the system will boot into AIX, the location code will be reported when
error log analysis is run under AIX diagnostics.
v If the system will boot into the system management services (SMS) menus, the SMS error log will
contain the location code associated with the error code. See "View Error Log" on page 232.
v If the system halted when the error occurred, the error code and location can be found in the LCD
progress indicator log, which can be accessed using the service processor menus. See "System
Information Menu" on page 205, then select Read Progress Indicators From Last System Boot. Find
the error code in the list that directed you to this note, and the location code should be a part of the
entry in the log.
Chapter 5. Error Code to FRU Index
133
Advertisement
Table of Contents
