Table of Contents
Advertisement
Step 1548-17
1. Follow the instructions on the screen to select the system console.
2. When the DIAGNOSTIC OPERATING INSTRUCTIONS screen is displayed, press Enter.
3. Select Advanced Diagnostics Routines.
4. If the terminal type has not been defined, you must use the Initialize Terminal option on the
FUNCTION SELECTION menu to initialize the AIX diagnostic environment before you can continue
with the diagnostics. This is a separate operation from selecting the console display.
5. If the NEW RESOURCE screen displays, select an option from the bottom of the screen.
Note: Adapters or devices that require supplemental media are not shown in the new resource list. If
the system has adapters or devices that require supplemental media, select option 1.
6. When the DIAGNOSTIC MODE SELECTION screen is displayed, press Enter.
7. Select All Resources (if you were sent here from "Step 1548-21" on page 100, select the adapter or
device that you loaded from the supplemental media).
Did you get an SRN?
NO
Go to "Step 1548-19" on page 100.
YES
Go to "Step 1548-18."
Step 1548-18
Look at the FRU part numbers associated with the SRN.
Have you exchanged all the FRUs that correspond to the failing function codes (FFCs)?
NO
Exchange the FRU with the highest failure percentage that has not been changed.
Repeat this step until all the FRUs associated with the SRN have been exchanged or diagnostics
run with no trouble found. Run diagnostics after each FRU is exchanged.
If the CEC backplane or a network adapter is removed, see notes on page 41.
Go to "MAP 0410: Repair Checkout" in the RS/6000 Eserver pSeries Diagnostic Information for
Multiple Bus Systems.
YES
If the symptom did not change and all the FRUs have been exchanged, call service support for
assistance.
Chapter 3. Maintenance Analysis Procedures (MAPs)
99
Advertisement
Table of Contents
