IBM 9114-275 - IntelliStation POWER 275 Service Manual page 127

Table 1. Service Processor Checkpoints (continued)
Checkpoint
9109
910A
910B
910C
910D
910E
910F
9110
9111
9112
9113
9114
9115
9116
9117
9119
9184
91C4
91FF
9200
9300
9301
9302
9303
9380
Description
ABIST
Non-processor scan interface BATs and
LBIST
Wire test
Initialize main storage (system memory)
Configure processors
Configure and initialize I/O
Test and initialize main storage (system
memory)
Free IPL LIDs
Load run-time LIDS
Load dump LIDs
Enable attention
Enable function 22
Load system IPL program
Load system data areas (NACA/PACA)
Start system IPL program
Waiting for VPD collection to complete
Firmware image being loaded into service
processor's control storage during firmware
update.
Flash update pending, either a firmware
update or hypervisor dump.
Control being handed to system processor
from service processor
Scan interface BATs
Logic BIST
Scanned ABIST
Dedicated ABIST
Dedicated ABIST array fuse repair
calculation
Built-in-self-test (BIST)
Action/
Possible Failing FRU
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
1. Remove, then reapply power to the
system. If the service processor enters
recovery mode, (indicated by A1FD
0000 in the display), attempt to update
the firmware again in recovery mode. If
the service processor comes up to the
OK prompt, try again to update the
firmware using the service processor
menus.
2. Call service support.
Note: This checkpoint may be displayed
during the firmware update process. The
checkpoint may be displayed for a long
period of time during the process. If
process does not complete, the system
may be hung.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 1 on page 112.
See note 2 on page 112.
Chapter 4. Checkpoints
109