Table of Contents
Advertisement
Step 1548-19
Does the system have adapters or devices that require supplemental media?
NO
Go to "Step 1548-20."
YES
Go to "Step 1548-21."
Step 1548-20
Consult the PCI adapter configuration documentation for your operating system to verify that all installed
adapters are configured correctly.
Go to "MAP 0410: Repair Checkout" in the RS/6000 Eserver pSeries Diagnostic Information for Multiple
Bus Systems.
If the symptom did not change and all the FRUs have been exchanged, call service support for assistance.
Step 1548-21
1. Select Task Selection.
2. Select Process Supplemental Media and follow the onscreen instructions to process the media.
Supplemental media must be loaded and processed one at a time.
Did the system return to the TASKS SELECTION SCREEN after the supplemental media was
processed?
NO
Go to "Step 1548-22."
YES
Press F3 to return to the FUNCTION SELECTION screen.
Go to "Step 1548-17" on page 99, substep 4.
Step 1548-22
The adapter or device is probably defective.
If the supplemental media is for an adapter, replace the FRUs in the following order:
1. Adapter
2. CEC backplane (see notes on page 41)
If the supplemental media is for a device, replace the FRUs in the following order:
1. Device and any associated cables
2. The adapter to which the device is attached
Repeat this step until the defective FRU is identified or all the FRUs have been exchanged.
If the symptom did not change and all the FRUs have been exchanged, call service support for assistance.
If the symptom has changed, check for loose cards, cables, and obvious problems. If you do not find a
problem, go to the "Quick Entry MAP" on page 43 and follow the instructions for the new symptom.
Go to "MAP 0410: Repair Checkout" in the RS/6000 Eserver pSeries Diagnostic Information for Multiple
Bus Systems.
100
IntelliStation POWER 9114 Model 275 Service Guide
Advertisement
Table of Contents
