Creating A Curve; Creating A Circle - Brother PD-3000 Instruction Manual

Creating a curve

Commands to be used
Increase the number of plotting points to create a smoother curve. One to 99 points are available for plotting.
1. Select the sewing start point with
and then press .
2. Input the stitch length in 3 digits, and then press
.

Creating a circle

The following five commands are available for creating a circle
Creating a circle by specifying 3 points on the circumference (Input the overlap stitch counts
in
Specifying a diameter to create a clockwise circle (Input the overlap stitch counts in
Specifying a diameter to create a counterclockwise circle (Input the overlap stitch counts in
Specifying a radius to create a clockwise circle (Input the overlap stitch counts in
Specifying a radius to create a counterclockwise circle (Input the overlap stitch counts in
Input the following command to create a zigzag circle.
Input this command to create a zigzag circle. Input the zigzag width in
The zigzag width can be specified from 1.0 to 25.5 mm. To specify the width of 10.0 mm
or more, input
Example: Zigzag width
Input this command to create a zigzag circle.
Input the zigzag stitch length in
Example: Pitch
Input the stitch length in
Example: Pitch
0.5 mm
12.0 mm
This command represents completing creation of a curve.
.)
.)
.)
3.5mm
18.0mm
Input value
0.5mm 005
12.0mm 120
CHAPTER 4 PROGRAMMING WITH COMMANDS
.
Input value
005
120
, 3. Move the needle with
.
4. When the needle point is moved to the end
point, press
and input the width in 3 digits, then press
Input value
.
PD-3000
. Press
.
.)
.)
.
.
121