Juniper MEDIA FLOW MANAGER 2.0.2 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual page 45

Media Flow Manager Administrator's Guide
Static and Dynamic ARP Entries
View Static and Dynamic ARP Entries. See
•
IP address—The configured IP address for this entry.
•
MAC address—The physical address of this entry.
•
Interface—The port configured for this entry.
•
Active—Whether or not this entry is being used currently.
•
Static—Whether or not this entry comes from DNS.
Click Remove Selected to delete an entry. Click Save to make changes persistent.
Figure 19 System Config > ARP Page Detail
Add Static Entry
Add a new static ARP entry on the System Config > ARP page; you need the IP address and
MAC address of the system you want to add to the ARP cache as a static entry. See
Figure 20.
Click Add Entry to immediately apply changes; Cancel to revert to existing configuration.
Click Save at the top of the page to make changes persistent.
Figure 20 System Config > ARP Page Detail
Clear Dynamic ARP Cache
On the System Config > ARP page, click Clear to empty the ARP cache. See
CHAPTER 3 Media Flow Manager Web-Based Interface
Figure 19, next.
Figure 21.
System Config 45