Table of Contents
Advertisement
Media Flow Manager Administrator's Guide
Notes:
•
reload
be prompted to save these changes (do a write memory) first before rebooting. The
prompt is suppressed if confirmation of losing unsaved changes is disabled (with the no
cli default prompt confirm-unsaved command). You may also be prompted to confirm
the reload regardless of whether there are unsaved changes or not. This prompt is
contingent on a separate configuration setting, controlled with the [no] cli default prompt
confirm-reload command. If both prompts are enabled, and the configuration was
unsaved, you are prompted twice.
•
force
variant. There is also never any confirmation, whether or not there are any unsaved
changes to the configuration
•
halt
operation (requiring the management subsystem, which is almost any management
operation), the regular reload [halt] command blocks until it is finished.
•
noconfirm
reset
Reset configuration, delete logs, and all other data.
reset factory [keep-all-config] [keep-basic] [reboot]
Notes:
•
reset factory
does not just involve configuration (done with the configuration revert command
instead), but everything on the system: logs, stats, CLI command history, system image
files (not the image installations), as well as resetting the configuration to factory defaults
and deleting all other configuration files. The system halts after this process, unless the
reboot option is set, in which case it reboots.
•
keep-all-config
not delete any other configuration files. You are prompted for confirmation before
honoring this command, unless confirmation is disabled with the no cli default
prompt confirm-reset command.
•
keep-basic
•
reboot
service-director
Configure service-director parameters. Entity = city, continent, country, isp, state, or zip value.
See
"Configure Service Director" on page 83
service-director
crossdomain
domain <string>
xml-response <name>
query-url-host {<hostname> | <IP_address>}
activate
—Reboot the system. If there are unsaved changes to the configuration, you may
—Reboot the system immediately. This reboots the system, and there is no halt
—Shut down the system if reload halt. If the system is busy performing another
—Suppresses the confirmations.
—'Scrub' the system clean, resetting it entirely to its factory state. This
—Preserve everything in the active configuration file, and also do
—Preserve licenses in the active configuration file.
—Reboot system after reset (instead of halting).
for implementation details.
CHAPTER 5 CLI Commands
reset
133
Advertisement
Table of Contents
