Table of Contents
Advertisement
Media Flow Manager Administrator's Guide
Figure 34
System Config > TACACS+ Page Detail
System Config > SNMP
Configure SNMP server options. See
SNMP Configuration
Enable SNMP and set SNMP authentication parameters. See
•
Enable SNMP—Enable the SNMP server. Un-check to disable; this stops serving SNMP
variables and the sending of SNMP traps.
•
Enable Communities—Enable or disable (by un-checking) community-based
authentication on this system. If disabled, the community configured is ignored.
•
Enable Traps—Enable or disable (by un-checking) sending SNMP traps from this system.
The SNMP server must be enabled first. See
•
Sys Contact—Set the syscontact variable served from the System MIB in MIB-II.
•
Sys Location—Set the syslocation variable served from the System MIB in MIB-II.
•
Read-Only Community—Set a name for read-only (ro) SNMP requests. The read-only
community means only queries are performed. In Release 2.0.2 only SNMP ro is
supported.
•
Default Trap Community—The string used if no specific string has been set for the trap.
Click Apply to complete SNMP configuration, Cancel to revert to existing configuration. Click
Save at the top of the page to make changes persistent across reboots.
CHAPTER 3 Media Flow Manager Web-Based Interface
for CLI details.
snmp-server
snmp traps
Figure
35, below, for graphic.
for details.
System Config
55
Advertisement
Table of Contents
