Table of Contents
Advertisement
CHAPTER 5 CLI Commands
•
enable
enabled and at least one non-DHCP interface is specified in the list, HTTP
connections are only accepted on those specified interfaces. When disabled, HTTP
connections are accepted on any interface. Default is enabled.
•
interface <interface_name>
If the interface is also running as a DHCP client, it is as if the interface was not added.
If DHCP is later turned off on this interface, it is as if the interface was then added to
the listen list. Default is eth0.
•
https
•
certificate regenerate
•
enable
based Management Console. Default is enabled. This setting is only meaningful if the
Management Console as a whole is enabled.
•
port
default, but does not disable HTTPS.
•
proxy
•
session
•
renewal
regenerated. Default is 30 minutes. Use no to reset default.
•
timeout
show web
Web-based Management Console settings.
web proxy
Manage Web proxy settings. Web proxy is disabled until you configure a host. See
"Configuring Web-Based Interface (Management Console) Proxy" on page 96
web proxy
auth
authtype {<auth_type> | none | basic}
basic password <plaintext_password> username <username>
host <IP_address> [port <TCP_port>]
Configure a Web proxy; use no web proxy to delete.
Notes:
•
—Configure authentication settings for the Web proxy.
auth
•
authtype
matters if a proxy is configured with web proxy host. The no variant resets the
authtype to its default, which is none.
•
•
•
basic
•
150
web
—Enable or disable (with no) the listen interface restricted list for HTTPD. If
—Configure HTTPS access to the Web-based Management Console.
—Enable or disable (with no) HTTPS (HTTP over SSL) access to the Web-
—Set the port number for HTTPS. Default is 443. The no variant resets it to the
—Configure Web proxy settings. See
—Configure session settings.
—Control the length of time before Web session cookies are automatically
—Configure time after which a session expires. Default is 150 minutes.
—Configure the type of authentication to be used with a Web proxy. Only
—No authentication required.
none
—HTTP basic authentication.
basic
—Configure HTTP basic authentication settings for the Web proxy.
password <plaintext_password>
basic authentication with an authenticating proxy. Only used if the web proxy
Media Flow Manager Administrator's Guide
—Add or delete (with no) interfaces to the listen list.
—Generate a new certificate to use for HTTPS.
"web proxy,"
—Specify a plaintext password for HTTP
Copyright © 2010, Juniper Networks, Inc.
below, for details.
for task details.
Advertisement
Table of Contents
