Table of Contents
Advertisement
CHAPTER 3 Media Flow Manager Web-Based Interface
•
Identity for ssh-dsa2 auth—The configured identity for ssh-dsa2 authenticated
logins; you set this on the CMC Setup > Identities page (see
below); any identities you've set you can choose from the drop-down list.
•
Username for ssh-rsa2 auth—A username for ssh-rsa2 logins; default is admin.
•
Identity for ssh-rsa2 auth—The configured identity for ssh-rsa2 authenticated
logins; you set this on the CMC Setup > Identities page (see
below); any identities you've set you can choose from the drop-down list.
•
Admin First Name, Last Name, E-mail, Phone Number, and Alternate Phone—
Enter the contact information of the administrator you are adding.
2. Click Add Media Flow Controller to complete the adding the new node. The new node
displays in the CMC-Media Flow Controller table at the top of the page. Also, a checkbox
for the new node displays on the Groups page for each configured group.
•
Click the node Name link in the table to open a new window to that appliance; login
required. All configuration options are dis-allowed (greyed-out) by default, you change
this by clicking the Config changes disabled change link at the top right of any page.
•
Click the Status link to open a Status Details page.
•
Click the Edit link to open an Edit page for the selected node.
3.
Click Save at the top of the page to make changes persistent across reboots.
Figure 59
CMC Setup Page (Add New Node)
70
CMC Setup
Media Flow Manager Administrator's Guide
CMC Setup >
CMC Setup >
Copyright © 2010, Juniper Networks, Inc.
Identities,
Identities,
Advertisement
Table of Contents
