Stats Chds - Juniper MEDIA FLOW MANAGER 2.0.2 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

CHAPTER 5 CLI Commands
When one of the windows expires, the alarms can be sent again (assuming no other window
and count limits are exceeded) and the tracking starts again.
Table 6 Stats Alarms
Stats Alarm
(unless otherwise noted, default rising error threshold is 200000000 Bps; rising clear threshold is 100000000 Bps)
cpu_util_indiv
disk_io *
fs_mnt
intf_util *
memory_pct_used *
paging
cmc_status
mfds_tx_bw
* Disabled by default; all others are enabled by default.

stats CHDs

Stats CHDs are shown in
CHDs are 1 data point.
Table 7 Stats CHDs
Stat CHD
cpu_util
cpu_util_ave
cpu_util_day
disk_io
fs_mnt_day
144 stats
Alarms
Average CPU utilization. The units for the cpu_util_indiv alarm are hundredths of
a point of the one-minute load average. For example, setting it to 100 causes an
alarm if the one-minute load average is ever over 1.0 when it is sampled. Default
rising error threshold is 90%; default rising clear threshold is 70%.
Disk I/O (input/output) in kilobytes per second. Default rising error threshold is
5120 kilobytes per sec; default rising clear threshold is 4608 kilobytes per sec.
Percent free filesystem space. Default falling error threshold is 7% of disk space
free; default falling clear threshold is 10% of disk space free.
Network utilization (in B/ps). Default rising error threshold is 10485760 bytes per
sec; default rising clear threshold is 9437184 bytes per sec.
Percent of physical memory in current in use. Default rising error threshold is 90% of
physical memory used; default rising clear threshold is 87% of physical memory
used.
Paging activity (page faults). The units for the paging alarm are number of pages
read from, or written to, the swap partition. The alarm is on the amount of paging
activity that has occurred over the past 20 seconds. Default rising error threshold
is 2000 page faults; default rising clear threshold is 1000 page faults.
CMC status check failure.
Transmissions out (TX) bandwidth of managed Media Flow Controllers is too high.
Table 7; unless otherwise noted, default interval and range for all
CPU utilization: percentage of time spent.
CPU utilization average: percentage of time spent. Default interval is 15 seconds,
default range is 60 seconds.
CPU utilization that day: percentage of time spent. Default interval and range are
1800 seconds.
Disk I/O (input/output) in kilobytes per second.
Filesystem usage average that day: bytes. Default interval and range are 300
seconds.
Media Flow Manager Administrator's Guide
Description
Description
Copyright © 2010, Juniper Networks, Inc.