Juniper MEDIA FLOW MANAGER 2.0.2 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual page 123

Media Flow Manager Administrator's Guide
no form of this command or by enabling zerofconf (described below). Use renew to force
a restart on the DHCP client for the specified interface. Default is disabled.
•
duplex
interface speed to auto. Setting one of the manual settings, half or full, also sets the
speed to a manual setting that is determined by querying the interface to find out its
current auto-detected state. Juniper Networks recommends keeping the default (auto).
Important!
and should be avoided.
•
identify
interface that number of seconds.
•
IP_address
•
—Set the interface MTU. Default is 1500. Juniper Networks recommends keeping the
mtu
default. Use no interface <interface_name> mtu to reset default.
•
shutdown
•
speed
to auto. Setting one of the manual settings (generally 10, 100, or 1000) also sets the
interface duplex to a manual setting that is determined by querying the interface to find
out its current auto-detected state.
with auto-configuration operations and should be avoided.
•
zeroconf
chooses a unique Link Local IPv4 address from the 169.254/16 block. It is an alternative
to DHCP. Default is disabled.
show interface [<interface_name> [configured] [brief]]
Display information about the specified interface, or all interfaces if one is not named. Includes
Admin state (whether or not the interface is enabled; up means it is enabled), Link state (up
means there is a cable plugged into that interface and it is "live" – connected to something
which is turned on at the other side, i.e. a switch, router, or another computer), and the current
TX (transmissions out) and RX (transmissions received) statistics. Detailed information is
given by default; use the subcommands to modify that. Notes:
•
brief
•
configured
ip
Configure Internet protocol (IP) settings. See
DNS, and Default Gateway" on page 61
ip
default-gateway {<next_hop_IP_address_or_Interface> [<interface>]}
dhcp
primary-intf <interface_name>
default-gateway yeild-to-static
domain-list <domain_name_for_resolving_hostnames> ...
host <hostname> <IP_address>
map-hostname
—Set or clear (with no) the interface duplex. Default is auto, which also sets
Changing the duplex setting can interfere with auto-configuration operations
—Select an interface and set identify <number> to flash the LED of that
—Set or clear (with no) this interface's IP address and netmask.
—Enable or disable (with no) the specified interface.
—Set or clear (with no) the interface speed. Default is auto, which also sets duplex
—Enable or disable use of Zeroconf on the specified interface. This randomly
—Display abbreviated runtime state, the interface statistics are excluded.
—Display configuration of the interface, rather than its runtime state.
Changing the speed setting can interfere
Important!
"Configuring Interfaces, Hostname, Domain List,
for task details.
CHAPTER 5 CLI Commands
Important!
ip 123