Table of Contents
Advertisement
Chapter 9
Ethernet Operation
Note
Click Finish.
Step 19
You now need to provision the Ethernet ports and assign ports to VLANs. For port provisioning
Step 20
instructions, see the
see the
Step 21
After assigning the ports to the VLANs, repeat Steps 1 – 19 at the second ONS 15454 Ethernet manual
cross-connect endpoint.
The appropriate STS circuit must exist in the non-ONS 15454 equipment to connect the two STSs
Note
from the ONS 15454 Ethernet manual cross-connect endpoints.
Procedure: Provision a Multicard EtherSwitch Manual Cross-Connect
Step 1
Display CTC for one of the ONS 15454 Ethernet circuit endpoints.
Step 2
Double-click one of the Ethernet cards that will carry the circuit.
Step 3
Click the Provisioning > Card tabs.
Step 4
Under Card Mode, verify that Multi-card EtherSwitch Group is checked.
If the Multicard-card EtherSwitch Group is not checked, check it and click Apply.
Step 5
Display the node view.
Repeat Steps 2 – 5 for any other Ethernet cards in the ONS 15454 that will carry the circuit.
Step 6
Click the Circuits tab and click Create.
Step 7
The Circuit Creation (Circuit Attributes) dialog box opens
Figure 9-18 Creating an Ethernet circuit
In the Name field, type a name for the circuit.
Step 8
From the Type pull-down menu, choose STS.
Step 9
November 2001
If the circuit information is not correct use the Back button, then redo the procedure with the
correct information. Alternately, you can click Finish, then delete the completed circuit and
start the procedure from the beginning.
"Provision Ethernet Ports" procedure on page
"Provision Ethernet Ports for VLAN Membership" procedure on page
Ethernet Circuit Configurations
9-3. For assigning ports to VLANs,
(Figure
9-18).
Cisco ONS 15454 Installation and Operations Guide
9-24.
9-19
Advertisement
Table of Contents
