Chapter 7
Card Provisioning
Click the Provisioning tab.
Step 2
Step 3
Depending on the setting you need to modify, click the Line, Thresholds, or STS subtab.
Note
Step 4
Modify the settings shown in
double-click the field and type the new number.
Table 7-6
Subtab
Line
November 2001
See
Chapter 10, "Alarm Monitoring and Management"
Behavior tab.
Table
EC1-12 Card Parameters
Parameter
Description
Port #
EC-1 card port #
Port Name
Name assigned to the port
(optional)
PJStsMon#
Sets the STS that will be used
for pointer justification. If set to
zero, no STS is used. See the
"Pointer Justification Count
Parameters" section on
page 8-12
Line Buildout
Defines the distance (in feet)
from backplane to next
termination point
Rx
For early EC1-12 card versions,
Equalization
equalization can be turned off if
the line length is short or the
environment is extremely cold;
Rx Equalization should
normally be set to On
Status
Places the port in or out of
service
7-6. For drop-down lists, select an item from the list. For numerics,
for more information.
Cisco ONS 15454 Installation and Operations Guide
Provisioning Electrical Cards
for information about the Alarm
Options
1 - 12
To enter a name for the port, click
the cell and type the name. To
change a name, double-click the
cell, then edit the text.
0 (default)
•
1
•
•
0 - 225 (default)
•
226 - 450
•
On (checked, default)
Off (unchecked)
•
•
Out of Service (default)
•
In Service
7-15