Performance Monitoring For Electrical Cards; Ec1 Card Performance Monitoring Parameters; Figure 8-11 Monitored Signal Types For The Ec1 Card; Figure 8-12 Pm Read Points On The Ec1 Card - Cisco 15454-TCC - Network Processor Card Operation Manual

Performance Monitoring for Electrical Cards

8.5 Performance Monitoring for Electrical Cards
The following sections define performance monitoring parameters for the EC1, DS1, DS1N, DS3,
DS3N, DS3-12E, DS3N-12E, and DS3XM electrical cards.

8.5.1 EC1 Card Performance Monitoring Parameters

Figure 8-11
reported for EC1.
integrated circuits (ASICs) produce performance monitoring parameters for the EC1 card.

Figure 8-11 Monitored signal types for the EC1 card

ONS 15454
Note The XX in the illustration above represents all PMs listed below with the given prefix and/or suffix.

Figure 8-12 PM read points on the EC1 card

Tx/Rx
Cisco ONS 15454 Installation and Operations Guide
8-14
shows signal types that support far-end PMs. Far-end performance monitoring is not
Figure 8-12 shows where overhead bytes detected on the application specific
Near End
EC1 Signal
EC1 OC48
EC1 Path (EC1 XX) Far End PMs Not Supported
STS Path (STS XX-P) Far End PMs Not Supported
ONS 15454
EC1 Card
LIU
Line Side
CV-S
ES-S
SES-S
SEFS-S
CV-L
SES-L
ES-L
UAS-L
FC-L
PPJC-Pdet
NPJC-Pdet
PPJC-Pgen
NPJC-Pgen
PMs read on Framer
Far End
EC1 Signal
Fiber
OC48
Framer
SONET Side
STS CV-P
STS ES-P
Path
STS FC-P
Level
BTC
STS SES-P
STS UAS-P
Chapter 8 Performance Monitoring
ONS 15454
EC1
XC10G Card OC-N
November 2001