Cisco 15454-TCC - Network Processor Card Operation Manual page 4

Contents
1.5 Backplane Access
1.6 EIA Installation
1.7 Fan-Tray Assembly Installation
1.8 Power and Ground Installation
1.9 Alarm, Timing, LAN, and Craft Pin Connections
1.10 Coaxial Cable Installation
1.11 DS-1 Cable Installation
Cisco ONS 15454 Installation and Operations Guide
iv
Procedure: Open the Front Cabinet Compartment (Door)
Procedure: Remove the Front Door
1-14
Procedure: Remove the Backplane Sheet Metal Covers
1.5.1 Lower Backplane Cover
Procedure: Remove the Lower Backplane Cover
1.5.2 Alarm Interface Panel
1-17
1.6.1 BNC EIA
1-17
1.6.2 High-Density BNC EIA
1.6.3 SMB EIA
1-19
1.6.4 AMP Champ EIA
1-20
Procedure: Install a BNC, High-Density BNC, or SMB EIA
Procedure: Install the AMP Champ EIA
Procedure: Install the Bottom Brackets and Air Filter
Procedure: Install the Fan-Tray Assembly
Procedure: Install Redundant Power Feeds
1.9.1 Alarm Installation
1-33
Procedure: Install Alarm Wires on the Backplane
1.9.2 Timing Installation
Procedure: Install Timing Wires on the Backplane
1.9.3 LAN Installation
1-34
Procedure: Install LAN Wires on the Backplane
1.9.4 TL1 Craft Interface Installation
Procedure: Install Craft Interface Wires on the Backplane
1.10.1 BNC Connector Installation
Procedure: Install Coaxial Cable With BNC Connectors
1.10.2 High-Density BNC Connector Installation
Procedure: Install Coaxial Cable With High-Density BNC Connectors
1.10.3 SMB Connector Installation
Procedure: Install Coaxial Cable with SMB Connectors
1-39
1.11.1 Twisted Pair Wire-Wrap Installation
Procedure: Install DS-1 Cables Using Electrical Interface Adapters (Balun)
1.11.2 AMP Champ Connector Installation
1-13
1-15
1-16
1-16
1-18
1-24
1-25
1-27
1-28
1-30
1-32
1-33
1-35
1-35
1-36
1-36
1-37
1-38
1-39
1-41
1-12
1-15
1-22
1-26
1-33
1-34
1-36
1-36
1-38
1-38
1-40
November 2001