Cisco 15454-TCC - Network Processor Card Operation Manual page 20

Figures
Figure 9-4 A Single-card EtherSwitch configuration
Figure 9-5 A Multicard EtherSwitch point-to-point circuit
Figure 9-6 A Single-card Etherswitch point-to-point circuit
Figure 9-7 Provisioning an Ethernet circuit
Figure 9-8 Choosing a circuit source
Figure 9-9 A shared packet ring Ethernet circuit
Figure 9-10 Choosing a VLAN name and ID
Figure 9-11 Selecting VLANs
Figure 9-12 Adding a span
Figure 9-13 Viewing a span
Figure 9-14 A Hub and Spoke Ethernet circuit
Figure 9-15 Ethernet manual cross-connects
Figure 9-16 Creating an Ethernet circuit
Figure 9-17 Selecting VLANs
Figure 9-18 Creating an Ethernet circuit
Figure 9-19 Selecting VLANs
Figure 9-20 A Q-tag moving through a VLAN
Figure 9-21 The priority queuing process
Figure 9-22 Configuring VLAN membership for individual Ethernet ports
Figure 9-23 An STP blocked path
Figure 9-24 The spanning tree map on the circuit screen
Figure 9-25 MAC addresses recorded in the MAC table
Figure 9-26 Creating RMON thresholds
Figure 10-1 Viewing alarms in the CTC node view
Figure 10-2 Selecting the Affected Circuits option
Figure 10-3 Highlighted circuit appears
Figure 10-4 Viewing fault conditions retrieved under the Conditions tabs
Figure 10-5 Viewing all alarms reported for the current session
Figure 10-6 The LCD panel
Figure 10-7 Alarm profiles screen showing the default profiles of the listed alarms
Figure 10-8 Node view of a DS1 alarm profile
Figure 10-9 Card view of a DS1 alarm profile
Figure 10-10 The suppress alarms checkbox
Figure 11-1 A basic network managed by SNMP
Figure 11-2 An SNMP agent gathering data from an MIB and sending traps to the manager
Cisco ONS 15454 Installation and Operations Guide
xx
9-5
9-8
9-8
9-10
9-11
9-12
9-12
9-13
9-14
9-17
9-17
9-18
9-19
9-20
9-23
9-24
9-26
9-33
10-2
10-4
10-5
10-8
10-12
10-12
10-14
11-2
9-7
9-7
9-25
9-28
9-30
10-6
10-7
10-9
11-2
November 2001