Procedure: Reference The Jre (Solaris Installations Only); Connecting Pcs To The Ons 15454; Direct Connections To The Ons 15454; Procedure: Creating A Direct Connection To An Ons 15454 - Cisco 15454-TCC - Network Processor Card Operation Manual

Operation guide
Hide thumbs Also See for 15454-TCC - Network Processor Card:
Table of Contents

Advertisement

Chapter 2
Software Installation

Procedure: Reference the JRE (Solaris installations only)

Step 1
Run the Control Panel by typing:
[JRE]/j2rel1_3_0_01/bin/ControlPanel
Click the Advanced tab.
Step 2
From the combo box, select [JRE]/j2rel1_3_0_01. If the JRE is not found, select other and enter the
Step 3
following in the Path text box:
[JRE]/j2rel1_3_0_01
Click Apply.
Step 4

2.4 Connecting PCs to the ONS 15454

You can connect a PC to the ONS 15454 using the RJ-45 LAN port on the TCC+ or the LAN 1 pins on
the ONS 15454 backplane. For a list of LAN pin assignments, see
15454 must have a unique IP address that you use to access the ONS 15454. The address is displayed on
the front panel LCD. The initial IP address, 192.1.0.2, is the default address for ONS 15454 access and
configuration. Each computer used to communicate with the ONS 15454 should have only one IP
address.
Note
Do not use dual network interface cards (NIC) or an enabled NIC card and dial-up adapter at the same
time; this hampers communication between CTC and ONS 15454s.

2.4.1 Direct Connections to the ONS 15454

A direct PC to ONS 15454 connection means your computer is physically connected to the ONS 15454.
This is most commonly done by connecting a CAT-5 straight-through cable from your PC NIC card to
the RJ-45 port on the TCC+. However, direct connections include connections to switches or hubs to
which the ONS 15454 is physically connected. To connect to the ONS 15454 with a direction
connection, you must:

Procedure: Creating a Direct Connection to an ONS 15454

Step 1
Attach a CAT-5 cable from the PC NIC card to one of the following:
Step 2
Use the steps in
November 2001
Set up Windows on your PC for direct connections
Attach cables from the PC to the ONS 15454
Test your connection
RJ-45 jack on the ONS 15454 TCC+ card
RJ-45 jack on a hub or switch to which the ONS 15454 is physically connected
Table 2-3
to set up Windows for direct connections to an ONS 15454 when:
Connecting PCs to the ONS 15454
Table 1-2 on page
Cisco ONS 15454 Installation and Operations Guide
1-34. Each ONS
2-5

Advertisement

Table of Contents
loading

Table of Contents