Table 1-1 Installation Tasks; Installation Equipment - Cisco 15454-TCC - Network Processor Card Operation Manual

Operation guide
Hide thumbs Also See for 15454-TCC - Network Processor Card:
Table of Contents

Advertisement

Chapter 1
Hardware Installation
The ONS 15454 is powered using -48V DC power. Negative, return, and ground power terminals are
accessible on the backplane.
Table 1-1
Table 1-1
Task
Mount the ONS 15454 in the rack.
Install the EIAs.
Install the fan-tray assembly.
Ground the equipment.
Run the power cables and fuse the
power connections.
Connect the backplane pins.
Install the coaxial cable and DS-1
cable on the back of the unit.
Install the cards.
Install the fiber-optic cables.
In this chapter, the terms "ONS 15454" and "shelf assembly" are used interchangeably. In the
Note
installation context, these terms have the same meaning. Otherwise, shelf assembly refers to the
physical steel enclosure that holds cards and connects power, and ONS 15454 refers to the entire
system, both hardware and software.
Install the ONS 15454 in compliance with your local and national electrical codes:
Read the installation instructions before you connect the system to its power source.
Warning
Warning
Dispose of this product according to all national laws and regulations.

1.2 Installation Equipment

You will need the following tools and equipment to install and test the ONS 15454.
November 2001
lists the tasks required to install an ONS 15454.
Installation Tasks
United States: National Fire Protection Association (NFPA) 70; United States National Electrical
Code
Canada: Canadian Electrical Code, Part I, CSA C22.1
Other countries: If local and national electrical codes, are not available, refer to IEC 364, Part 1
through Part 7.
Reference
See the
"Rack Installation" section on page
See the
"Install a BNC, High-Density BNC, or SMB EIA"
procedure on page
1-22.
See the
"Fan-Tray Assembly Installation" section on page
See the
"Power and Ground Installation" section on page
See the
"Power and Ground Installation" section on page
See the
"Alarm, Timing, LAN, and Craft Pin Connections"
section on page
1-32.
See the
"Coaxial Cable Installation" section on page 1-36
the
"DS-1 Cable Installation" section on page
See the
"Card Installation" section on page
See the
"Fiber-Optic Cable Installation" section on page
Cisco ONS 15454 Installation and Operations Guide
Installation Equipment
1-5.
1-25.
1-28.
1-28.
and
1-39.
1-44.
1-52.
1-3

Advertisement

Table of Contents
loading

Table of Contents