Table of Contents
Advertisement
ONS 15454 IP Addressing Scenarios
Figure 4-7
LAN B
CTC Workstation #2
IP Address 192.168.1.200
Subnet Mask 255.255.255.0
Default Gateway = N/A
4.2.7 Scenario 7: Using OSPF
Open Shortest Path First (OSPF) is a link state Internet routing protocol. Link state protocols use a "hello
protocol" to monitor their links with adjacent routers and to test the status of their links to their
neighbors. Link state protocols advertise their directly-connected networks and their active links. Each
link state router captures the link state "advertisements" and puts them together to create a topology of
the entire network or area. From this database, the router calculates a routing table by constructing a
shortest path tree. Routes are continuously recalculated to capture ongoing topology changes.
ONS 15454s use the OSPF protocol in internal ONS 15454 networks for node discovery, circuit routing,
and node management. You can enable OSPF on the ONS 15454s so that the ONS 15454 topology is
sent to OSPF routers on a LAN. Advertising the ONS 15454 network topology to LAN routers eliminates
Cisco ONS 15454 Installation and Operations Guide
4-10
Scenario 6: Static route for multiple CTCs
CTC Workstation #1
IP Address 192.168.1.100
Subnet Mask 255.255.255.0
Default Gateway = N/A
ONS 15454 #2
IP Address 192.168.1.20
Subnet Mask 255.255.255.0
Default Router = N/A
Static Routes
Destination 192.168.1.200
Mask 255.255.255.255
Next Hop 192.168.1.20
Cost = 1
ONS 15454 #1
IP Address 192.168.1.10
Subnet Mask 255.255.255.0
Default Router = N/A
Static Routes
Destination 192.168.1.100
Mask 255.255.255.255
Next Hop 192.168.1.10
Cost = 1
SONET RING
Chapter 4
IP Networking
LAN A
ONS 15454 #3
IP Address 192.168.1.30
Subnet Mask 255.255.255.0
Default Router = N/A
Static Routes = N/A
November 2001
Advertisement
Table of Contents
