EIA Installation
Procedure: Install the AMP Champ EIA
Step 1
To remove the lower backplane cover, loosen the five screws that secure it to the ONS 15454 and pull it
away from the shelf assembly.
Step 2
Align the AMP Champ cover panel with the backplane and insert and tighten the nine perimeter screws
(P/N 48-0358) at 8-10 lbs.
Step 3
Align an AMP Champ card with the backplane connector and push until it fits snugly. Repeat until you
have installed all six AMP Champ cards.
Step 4
To secure each AMP Champ card to the cover panel, insert and tighten a screw (P/N 48-0003) at the top
of each card at 8-10 lbs.
Place the AMP Champ fastening plate along the bottom of the cover panel, and hand tighten the two
Step 5
thumbscrews.
Figure 1-19
Figure 1-19 Installing the AMP CHAMP EIA
Cisco ONS 15454 Installation and Operations Guide
1-24
shows an AMP Champ EIA installation.
Chapter 1
Hardware Installation
November 2001
Need help?
Do you have a question about the 15454-TCC - Network Processor Card and is the answer not in the manual?
Questions and answers