Monitoring And Maintaining Lac - Cisco 10000-2P2-2DC Software Configuration Manual

Chapter 5 Configuring the Layer 2 Tunnel Protocol Access Concentrator and Network Server
interface ATM4/0/0
no ip address
no atm ilmi-keepalive
!
interface ATM4/0/1
no ip address
no atm ilmi-keepalive
!
interface ATM4/0/2
no ip address
no atm ilmi-keepalive
!
interface ATM4/0/3
no ip address
no atm ilmi-keepalive
!
interface GigabitEthernet5/0/0
no ip address
negotiation auto
!
interface Virtual-Template1
ip unnumbered Loopback1
keepalive 30
no peer default ip address
ppp authentication pap
!
ip default-gateway 23.3.0.4
ip classless
ip route 1.0.0.253 255.255.255.255 23.3.0.4
no ip http server
ip pim bidir-enable
!
no cdp run
!
radius-server retransmit 3
radius-server authorization permit missing Service-Type
!
line con 0
exec-timeout 0 0
line aux 0
line vty 0 4
!
end

Monitoring and Maintaining LAC

To monitor and maintain the LAC, enter the following commands in privileged EXEC mode:
Command
Router# show running-config
OL-2226-23
Purpose
Displays the current configuration of the Cisco 10000 series
router, acting as the LAC device.
This command is useful in verifying that you successfully
configured the LAC features, such as the maximum number of
sessions per tunnel, the static domain name, and the LAC to
RADIUS communication for tunnel service authorization
Cisco 10000 Series Router Software Configuration Guide
Layer 2 Access Concentrator
5-21