Creating An On-Demand Pvc Directly - Cisco 10000-2P2-2DC Software Configuration Manual

ATM PVC Autoprovisioning
Command
Step 2
Router(config-if)# range [range-name] pvc
start-vpi/start-vci end-vpi/end-vci
Step 3
Router(config-if-atm-range)# class-range
class-name
Example 8-3
Example 8-3
Router(config)# int atm 3/0/0.1 multipoint
Router(config-subif)# atm pppatm passive
Router(config-subif)# range pvc 100/100 100/200
Router(config-subif-atm-range)# class-range myclass
Applying a VC Class to a Specific PVC Within a PVC Range
To apply a VC class to a specific PVC within a PVC range, enter the following commands beginning in
global configuration mode:
Command
Step 1
Router(config)# interface atm slot/0
[.subinterface-number {multipoint |
point-to-point}]
Step 2
Router(config-if)# range [range-name] pvc
start-vpi/start-vci end-vpi/end-vci
Step 3
Router(config-if-atm-range)# pvc-in-range
[pvc-name] [vpi/vci]
Step 4
Router(config-if-atm-range-pvc)# class-vc
vc-class-name
Example 8-4
Example 8-4
Router(config)# int atm 3/0/0.1 multipoint
Router(config-subif)# atm pppatm passive
Router(config-subif)# range pvc 100/100 100/200
Router(config-subif-atm-range)# pvc-in-range 100/100
Router(config-subif-atm-range-pvc)# class-vc myclass

Creating an On-Demand PVC Directly

To configure an on-demand PVC directly on an individual PVC, a PVC range, or a specific PVC within
PVC range, perform the following tasks:
•
•
•
Cisco 10000 Series Router Software Configuration Guide
8-8
applies the VC class myclass to the PVC range 100/100 to 100/200.
Applying a VC Class to a PVC Range
applies the VC class myclass to PVC 100/100 in the PVC range 100/100 to 100/200.
Applying a VC Class to a Specific PVC Within a PVC Range
Enabling ATM PVC Autoprovisioning on an Individual PVC, page 8-9
Enabling ATM PVC Autoprovisioning on a Range of PVCs, page 8-9
Enabling ATM PVC Autoprovisioning on a Specific PVC Within a PVC Range, page 8-10
Chapter 8 Configuring ATM Permanent Virtual Circuit Autoprovisioning
Purpose
Specifies the range of PVCs and enters atm-range configuration
mode.
Applies the VC class on the range of PVCs.
Purpose
Specifies the ATM interface and enters interface or subinterface
configuration mode.
Specifies the range of PVCs and enters atm-range configuration
mode.
Specifies an individual PVC within a PVC range.
Applies the VC class on the individual PVC within the PVC
range.
OL-2226-23