Verifying The Configuration; Configuration Examples Of Ethernet To Vlan-Bridged - Cisco 10000-2P2-2DC Software Configuration Manual

Chapter 21 Configuring L2VPN Interworking
Command or Action
Step 4
encapsulation mpls
Example:
Router(config-pw)# encapsulation mpls
Step 5
interworking {ethernet|ip}
Example:
Router(config-pw)# interworking ethernet

Verifying the Configuration

You can verify the AToM configuration by using the show mpls l2transport vc detail command. In the
following example, the interworking type appears in bold.
PE1
Router# show mpls l2transport vc detail
Local interface: Fa1/1/0 up, line protocol up,
Ethernet up
Destination address: 10.9.9.9, VC ID: 123, VC
status: up
Preferred path: not configured
Default path: active
Tunnel label: 17, next hop 10.1.1.3
Output interface: Fa4/0/0, imposed label
stack {17 20}
Create time: 01:43:50, last status change time:
01:43:33
Signaling protocol: LDP, peer 10.9.9.9:0 up
MPLS VC labels: local 16, remote 20
Group ID: local 0, remote 0
MTU: local 1500, remote 1500
Remote interface description:
Sequencing: receive disabled, send disabled
VC statistics:
packet totals: receive 15, send 4184
byte totals: receive 1830, send 309248
packet drops: receive 0, send 0
Configuration Examples of Ethernet to VLAN—Bridged
This section contains examples of Ethernet to VLAN for both local switching (LS) and AToM:
•
•
OL-2226-23
Ethernet to VLAN over LS—Bridged: Example
Ethernet to VLAN over AToM—Bridged: Example
Purpose
Specifies the tunneling encapsulation.
Specifies the type of pseudowire and the type of traffic that
can flow across it.
PE2
Router# show mpls l2transport vc detail
Local interface: Fa2/0.3 up, line protocol up, Eth VLAN
10 up
MPLS VC type is Ethernet, interworking type is
Ethernet
Destination address: 10.8.8.8, VC ID: 123, VC status:
up
Preferred path: not configured
Default path: active
Tunnel label: 16, next hop 10.1.1.3
Output interface: Fa6/0, imposed label stack {16 16}
Create time: 00:00:26, last status change time:
00:00:06
Signaling protocol: LDP, peer 10.8.8.8:0 up
MPLS VC labels: local 20, remote 16
Group ID: local 0, remote 0
MTU: local 1500, remote 1500
Remote interface description:
Sequencing: receive disabled, send disabled
VC statistics:
packet totals: receive 5, send 0
byte totals: receive 340, send 0
packet drops: receive 0, send 0
Cisco 10000 Series Router Software Configuration Guide
Bridged Interworking
21-3