Removing A Member Link From An Mlp Bundle - Cisco 10000-2P2-2DC Software Configuration Manual

Configuring MLP Bundles and Member Links
Command
Step 1
Router(config)# interface type number
Step 2
Router(config-if)# ppp chap hostname
hostname
Step 3
Router(config-if)# ppp multilink group
group-number

Removing a Member Link from an MLP Bundle

To remove a member link from an MLP bundle, enter the following commands beginning in global
configuration mode:
Command
Step 1
Router(config-if)# interface type number
Step 2
Router(config-if)# no ppp multilink group
group-number
Cisco 10000 Series Router Software Configuration Guide
22-36
Chapter 22 Configuring Multilink Point-to-Point Protocol Connections
Purpose
Specifies the interface that you want to move to a different MLP
bundle. Enters interface or subinterface configuration mode.
type specifies the type of interface (for example, ATM).
number specifies the interface number and is the
slot/module/port.subinterface number or the
slot/module/port.channel:controller-number of the interface (for
example, ATM 1/0/0.1).
(Optional) Identifies the hostname sent in the Challenge
Handshake Authentication Protocol (CHAP) challenge.
hostname is the name of the bundle group. This name uniquely
identifies the bundle.
If you configure this command on the bundle and its
Note
member links, specify the same identifier for both the
bundle and the member links.
Moves this interface to the MLP bundle you specify.
group-number identifies the multilink group. Change this
group-number to the new MLP group group-number. Valid values
are:
• MLP over Serial—1 to 9999 (Release 12.2(28)SB and later)
or from 1 to 9999 and 65,536 to 2,147,483,647
(Release 12.2(31)SB2 and later).
Single-VC MLP over ATM—10,000 and higher.
•
Multi-VC MLP over ATM—1 to 9999 (Release 12.2(28)SB
•
and later) or from 1 to 9999 and 65,536 to 2,147,483,647
(Release 12.2(31)SB2 and later).
Purpose
Specifies the member link that you want to remove from the MLP
bundle. Enters interface configuration mode.
type specifies the type of interface (for example, ATM).
number specifies the interface number and is the
slot/module/port.subinterface number or the
slot/module/port.channel:controller-number of the interface (for
example, ATM 1/0/0.1).
Removes the member link from the MLP group.
group-number is the number of the MLP group from which you
want to remove the member link.
OL-2226-23