Table of Contents
Advertisement
Chapter 8
Configuring ATM Permanent Virtual Circuit Autoprovisioning
Example 8-1
idle-timeout timer for 300 seconds. The configuration of the idle-timeout timer is optional.
Example 8-1
Router(config)# vc-class atm myclass
Router(config-vc-class)# create on-demand
Router(config-vc-class)# idle-timeout 300
Applying the VC Class
To apply a VC class, perform the following tasks:
•
•
•
Applying a VC Class to an Individual PVC
To apply a VC class to a specific PVC, enter the following commands beginning in global configuration
mode:
Command
Step 1
Router(config)# interface atm slot/0
[.subinterface-number {multipoint |
point-to-point}]
Step 2
Router(config-if)# pvc [name] vpi/vci
Step 3
Router(config-if-atm-vc)# class-vc
vc-class-name
Example 8-2
Example 8-2
Router(config)# interface atm 3/0/0.1 multipoint
Router(config-subif)# atm pppatm passive
Router(config-subif)# pvc 100/100
Router(config-subif-atm-vc)# class-vc myclass
Applying a VC Class to a Range of PVCs
To apply a VC class to a range of PVCs, enter the following commands beginning in global configuration
mode:
Command
Step 1
Router(config)# interface atm slot/0
[.subinterface-number {multipoint |
point-to-point}]
OL-2226-23
creates a VC class named myclass, enables PVC autoprovisioning on the class, and sets the
Configuring a VC Class with PVC Autoprovisioning Enabled
Applying a VC Class to an Individual PVC, page 8-7
Applying a VC Class to a Range of PVCs, page 8-7
Applying a VC Class to a Specific PVC Within a PVC Range, page 8-8
applies the VC class myclass to PVC 100/100.
Applying a VC Class to an Individual PVC
Purpose
Specifies the ATM interface and enters interface or subinterface
configuration mode.
Specifies the ATM PVC and enters atm-vc configuration mode.
Applies the VC class on the PVC.
Purpose
Specifies the ATM interface and enters interface or subinterface
configuration mode.
Cisco 10000 Series Router Software Configuration Guide
ATM PVC Autoprovisioning
8-7
Advertisement
Table of Contents
Troubleshooting
