Atom - Cisco 10000-2P2-2DC Software Configuration Manual

Ethernet/VLAN to Frame Relay Interworking
FR DLCI to Ethernet VLAN 802.1Q
You can configure the FR DLCI to Ethernet VLAN 802.1Q feature on a router using the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Note
The following example shows how you can configure the FR DLCI to Ethernet VLAN 802.1Q feature
on a router using bridged interworking:
config t
frame-relay switching
interface serial 2/0/0:1
interface gigabitethernet 5/1/0.3
connect fr-vlan gigabitethernet 5/1/0.3 serial 2/0/0:1 100 interworking ethernet

AToM

Figure 21-9
configurations and provides examples:
•
•
FR DLCI to Ethernet Port
You can configure the FR DLCI to Ethernet port feature on a PE1 router using the following steps:
1.
2.
3.
4.
5.
6.
7.
Cisco 10000 Series Router Software Configuration Guide
21-24
config t
frame-relay switching
interface serial slot/subslot/port[:channel | .channel]
encapsulation frame-relay
frame-relay intf-type dce
frame-relay interface-dlci DLCI switched
interface [ fastethernet | gigabitethernet ] slot/subslot/port.subinterface
encapsulation dot1q VLAN-ID
connect connection-name [ fastethernet | gigabitethernet ] slot/subslot/port.subinterface serial
slot/subslot/port[:channel | .channel] interworking ethernet|ip
The order of the interfaces in the connect command is not important.
encapsulation frame-relay
frame-relay intf-type dce
frame-relay interface-dlci 100 switched
encapsulation dot1q 2
illustrates different AToM configurations. This section explains the following AToM
FR DLCI to Ethernet Port, page 21-24
FR DLCI to Ethernet VLAN 802.1Q, page 21-26
config t
mpls label protocol ldp
interface Loopback name
ip address local-ip-address local-mask
pseudowire-class name
encapsulation mpls
interworking ethernet|ip
Chapter 21 Configuring L2VPN Interworking
OL-2226-23