Table of Contents
Advertisement
Defining a Loopback Interface
To define a loopback interface, enter the following commands in global configuration mode:
Command
Step 1
Router(config)# interface loopback number
Step 2
Router(config)# ip vrf forwarding vrf
name
Step 3
Router(config)# ip address address mask
Creating an IP Address Pool
To an IP address pool, enter the following command in global configuration mode:
Command
Step 1
Router(config)# ip local pool start
address end address
Defining a Subscriber Profile
To define a subscriber profile, enter the following commands in global configuration mode:
Command
Step 1
Router(config)# subscriber authorization
enable
Step 2
Router(config)# subscriber profile
domain-name
Step 3
Router(config)# service local
Step 4
Router(config)# aaa attribute list aaa
attribute-list name
Defining an AAA Attribute List
To define AAA attribute list, enter the following commands in global configuration mode:
Command
Step 1
Router(config)# aaa attribute list aaa
attribute-list name
Step 2
Router(config)# attribute type addr-pool
pool_name protocol ip
Step 3
Router(config)# attribute type
ip-unnumbered loopback number service ppp
protocol ip
Step 4
Router(config)# attribute type vrf-id
vrf_name service ppp protocol ip
Cisco 10000 Series Router Software Configuration Guide
11-8
Chapter 11
Configuring Local AAA Server, User Database—Domain to VRF
Purpose
Defines a loopback for the PPP session.
Enables VRF forwarding.
Sets the IP address.
Purpose
Defines an IP pool from which the PPP sessions are IP addresses.
Purpose
Enables subscriber authorization.
Specifies the user name domain to match.
Specifies to perform local subscriber authorization.
Defines the AAA attribute list from which to get RADIUS
attributes and that is applied to the PPP session.
Purpose
Defines an AAA attribute list.
Defines an IP address pool to use.
Defines the loopback interface to use.
Defines the VRF to use.
OL-2226-23
Advertisement
Table of Contents
Troubleshooting
