Cisco 10000-2P2-2DC Software Configuration Manual page 103

Chapter 3 Configuring Remote Access to MPLS VPN
For more information, see the "Configuring Broadband Access: PPP and Routed Bridge Encapsulation"
Note
chapter in the Cisco IOS Wide-Area Networking Configuration Guide, Release 12.2.
Configuring a VPDN Group for PPPoE over ATM
To configure the physical interface that will carry the PPPoE session and link it to the appropriate virtual
template interface, enter the following commands beginning in global configuration mode:
Command
Step 1
Router(config)# vpdn enable
Step 2
Router(config)# vpdn group name
Step 3
Router(config-vpdn)# accept-dialin
Step 4
Router(config-vpdn-acc-in)# protocol pppoe
Step 5
Router(config-vpdn-acc-in)# virtual-template
template-number
Step 6
Router(config-vpdn)# pppoe limit per-vc
number
Configuring PPPoE on ATM Permanent Virtual Circuits
To configure PPPoE on a range of ATM PVCs, enter the following commands beginning in global
configuration mode:
Command
Step 1
Router(config)# interface atm
slot/0.subinterface-number multipoint
Step 2
Router(config-subif)# range [range-name]
pvc start-vpi/start-vci end-vpi/end-vci
Step 3
Router(config-if-atm-range)# encapsulation
aal5snap
Step 4
Router(config-if)# protocol pppoe
OL-2226-23
Purpose
Enables virtual private dial network (VPDN) configuration on
this router.
Associates a VPDN group with a customer or VPDN profile.
Creates an accept dial-in VPDN group.
Specifies the VPDN group to be used to establish PPPoE
sessions.
Specifies the virtual template interface to use to clone virtual
access interfaces (VAIs).
Specifies the maximum number of PPPoE sessions to be
established over a virtual circuit.
Purpose
Specifies an ATM multipoint subinterface.
Creates a range of PVCs.
Configures VC multiplexed encapsulation on a PVC range.
Specifies the VPDN group to be used to establish PPPoE
sessions on the PVC range.
Cisco 10000 Series Router Software Configuration Guide
Configuration Tasks for RA to MPLS VPN
3-19