Monitoring And Maintaining Lldp In Multivendor Networks - Cisco ASR 920 Series Configuration Manual Ethernet Router

Monitoring and Maintaining LLDP in Multivendor Networks

Command or Action
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 lldp timer rate
Example:
Device(config)# lldp timer 75
Step 4
end
Example:
Device(config)# end
Monitoring and Maintaining LLDP in Multivendor Networks
Perform this task to monitor and maintain LLDP in multivendor networks. This task is optional, and Steps 2
and 3 can be performed in any sequence.
SUMMARY STEPS
1. enable
2. show lldp [entry {* | word} | errors | interface [ethernet number]| neighbors [ethernet number| detail]|
traffic]
3. clear lldp {counters | table}
4. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
338
Using Link Layer Discovery Protocol in Multivendor Networks
Purpose
• Enter your password if prompted.
Enters global configuration mode.
Specifies the rate at which LLDP packets are sent every
second.
Returns to privileged EXEC mode.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.