Table of Contents
Advertisement
Chapter 21
Configuring L2VPN Interworking
Configuration Tasks and Examples
This section describes configuration tasks for and examples of two L2VPN technology solutions
•
•
Local Switching
Figure 21-8
•
•
FR DLCI to Ethernet Port
You can configure the FR DLCI to Ethernet port feature on a router using the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Note
Note
The following example shows how you can configure the FR DLCI to Ethernet Port feature on a router,
using routed interworking:
config t
frame-relay switching
interface serial 2/0/0:1
encapsulation frame-relay
frame-relay intf-type dce
frame-relay interface-dlci 100 switched
interface gigabitethernet 5/1/0
connect fr-enet gigabitethernet 5/1/0 serial 2/0/0:1 100 interworking ip
OL-2226-23
Local Switching
AToM
shows LS configurations. The following LS configurations and examples are described:
FR DLCI to Ethernet Port, page 21-23
FR DLCI to Ethernet VLAN 802.1Q, page 21-24
config t
frame-relay switching
interface serial slot/subslot/port[:channel | .channel]
encapsulation frame-relay
frame-relay intf-type dce
frame-relay interface-dlci DLCI switched
interface [ fastethernet | gigabitethernet ] slot/subslot/port
no ip address
connect connection-name [ fastethernet | gigabitethernet ] slot/subslot/port serial
slot/subslot/port[:channel | .channel] interworking ethernet|ip
The order of the interfaces in the connect command is not important.
For configuring routed interworking on the FR DLCI to Ethernet Port feature, enter all
commands except the no ip address command.
Ethernet/VLAN to Frame Relay Interworking
Cisco 10000 Series Router Software Configuration Guide
21-23
Advertisement
Table of Contents
Troubleshooting
