New Features In Cisco Ios Release 12.3(7)Xi7 - Cisco 10000-2P2-2DC Software Configuration Manual

10000 series
Table of Contents

Advertisement

Chapter 1
Broadband Aggregation and Leased-Line Overview
Note

New Features in Cisco IOS Release 12.3(7)XI7

The following features are new on the Cisco 10000 series router in Cisco IOS Release 12.3(7)XI7:
OL-2226-23
SSO—Multilink PPP (MLP) in the Stateful Switchover feature guide, located at the following URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1838/products_white_paper09186a00801ce6
f9.shtml
In Cisco IOS Release 12.2(28)SB, the Cisco 10000 series supports Route Processor Redundancy
Plus (RPR+) and Stateful Switchover (SSO). However, for broadband aggregation features the
Cisco 10000 series supports RPR+ only.
Template ACLs in
Chapter 25, "Configuring Template ACLs"
Two-Rate Policer (also known as Dual Rate Three Color Policer) in the Cisco 10000 Series Router
Quality of Service Configuration Guide, located at the following URL:
http://www.cisco.com/en/US/products/hw/routers/ps133/products_configuration_guide_book0918
6a00805b9497.html
Cisco IOS Release 12.2(28)SB Upgrade in the Upgrading to Cisco IOS Release 12.2(28)SB on a
Cisco 10000 Series Router, located at the following URL:
http://www.cisco.com/en/US/products/hw/routers/ps133/products_upgrade_guides09186a008059a
dee.html
Dynamic Subscriber Bandwidth Selection in the Cisco 10000 Series Router Quality of Service
Configuration
Guide, located
http://www.cisco.com/en/US/products/hw/routers/ps133/products_configuration_guide_book0918
6a00805b9497.html
L2TP Domain
Screening, located
http://www.cisco.com/en/US/products/sw/iosswrel/ps5413/products_feature_guide09186a00805a0
782.html
Per Session Queuing and Shaping for PTA in the Cisco 10000 Series Router Quality of Service
Configuration Guide, located at the following URL:
http://www.cisco.com/en/US/products/hw/routers/ps133/products_configuration_guide_book0918
6a00805b9497.html
Support for IP over Q-in-Q (IPoQ-in-Q)—IP packets that are double-tagged for Q-in-Q VLAN tag
termination on the subinterface level. For more information, see the PPPoE—QinQ Support feature
guide, located at the following URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_feature_guide09186a00801f0
f4a.html
VRF-Aware VPDN
Tunnels, located
http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080509
f81.html
at the following URL:
at the following URL:
at the following URL:
Cisco 10000 Series Router Software Configuration Guide
New Features, Enhancements, and Changes
1-25

Advertisement

Table of Contents
loading

This manual is also suitable for:

1000510008

Table of Contents