Cisco 10000-2P2-2DC Software Configuration Manual page 74

Configuring the Cisco 10000 Series Router for High Scalability
Table 2-7
Command
help
hold-queue
lan-name
lapb
load-interval
locaddr-priority
logging
loopback
mac-address
max-reserved-bandwidth
mpoa
multilink
multilink-group
netbios
ntp
priority-group
qos pre-classify
random-detect
roles
sap-priority
sdlc
serial
Cisco 10000 Series Router Software Configuration Guide
2-12
Interface-Specific Commands That Prevent PPP Scaling (continued)
Function
Provides a description of the interactive help
system.
Sets the hold queue depth.
Specifies a name for the LAN that is attached to
the interface.
X.25 Level 2 parameters (Link Access Procedure,
Balanced).
Specifies the interval for load calculation for an
interface.
Assigns a priority group.
Configures logging for an interface.
Configures the internal loopback on an interface.
Manually sets the MAC address for an interface.
Specifies the maximum reservable bandwidth on
an interface.
Multiprotocol over ATM (MPOA) interface
configuration commands.
Configures multilink parameters.
Puts the interface in a multilink bundle.
Defines Network Basic Input/Output System
(NetBIOS) access list or enables name-caching.
Configures the Network Time Protocol (NTP).
Assigns a priority group to an interface.
Enables quality of service (QoS) preclassification.
Enables weighted random early detection
(WRED) on an interface.
Specifies roles (by entering roles mode).
Assigns a priority group.
Configures Synchronous Data Link Control
(SDLC) to Logical Link Control type 2 (LLC2)
translation.
Serial interface commands.
Chapter 2 Scalability and Performance
OL-2226-23