Atom - Cisco 10000-2P2-2DC Software Configuration Manual

Chapter 21 Configuring L2VPN Interworking
frame-relay intf-type dce
frame-relay interface-dlci 100 switched
connect atm-dlci atm 2/0/0 0/200 serial 2/0/0:1 100 interworking ip

AToM

Figure 21-9
configurations and provides examples:
FR DLCI to ATM AAL5
To configure the FR DLCI to ATM AAL5 feature on a PE1 router, use the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
To configure the FR DLCI to ATM AAL5 feature on a PE2 router, use the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
The following example shows how to configure the FR DLCI to ATM AAL5 feature on a PE1 router:
OL-2226-23
illustrates different AToM configurations. This section explains the FR DLCI to ATM AAL5
config t
mpls label protocol ldp
interface Loopback<name>
ip address local-ip-address local-mask
pseudowire-class name
encapsulation mpls
interworking ip
interface atm slot/subslot/port
pvc vpi/vci l2transport
encapsulation aal5snap
xconnect remote-ip-address vc-id pw-class name
config t
mpls label protocol ldp
interface Loopback<name>
ip address local-ip-address local-mask
pseudowire-class name
encapsulation mpls
interworking ip
frame-relay switching
interface serial slot/subslot/port[:channel | .channel]
encapsulation frame-relay
frame-relay intf-type dce
frame-relay interface-dlci DLCI switched
connect mpls serial slot/subslot/port[:channel | .channel] DLCI l2transport
xconnect remote-ip-address vc-id pw-class name
ATM to Frame Relay—Routed Interworking
Cisco 10000 Series Router Software Configuration Guide
21-29