Configuration Example-Frame Relay Over Mpls - Cisco 10000-2P2-2DC Software Configuration Manual

Configuration Example—Frame Relay over MPLS
Configuration Example—Frame Relay over MPLS
Example 20-31
and PE2, and on two customer edge routers, CE1 and CE2. The topology for the example is shown in
Figure
Figure 20-7
ser8/0/0/1:0
(dlci=17)
(dlci=18)
For the AToM VCs to come up, MPLS/LDP and a routing protocol need to be run in the core network
(PE1---P----PE2). PE1 and PE2 show that they are enabled with the OSPF routing protocol and
MPLS/LDP.
Example 20-31 Frame Relay over MPLS Configuration
CE1 Configuration for Frame Relay
================================
interface Serial8/0/0.1/1:0
no ip address
encapsulation frame-relay
no fair-queue
frame-relay lmi-type q933a
frame-relay intf-type dce
interface Serial8/0/0.1/1:0.1 point-to-point
ip address 192.1.1.1 255.255.255.0
frame-relay interface-dlci 17
!
interface Serial8/0/0.1/1:0.2 point-to-point
ip address 192.1.2.1 255.255.255.0
frame-relay interface-dlci 18
PE1 Configuration for LDP and AToM VC
==================================
!Enabling LDP
mpls ldp graceful-restart timers neighbor-liveness 300
mpls ldp graceful-restart timers max-recovery 600
mpls ldp graceful-restart
mpls ldp router-id Loopback0 force
mpls label protocol ldp
!Define Loopback address for LDP protocol
interface Loopback0
ip address 1.1.1.1 255.255.255.255
!Enable MPLS/LDP on the core interface
interface POS4/0/0
ip address 50.0.0.1 255.0.0.0
mpls label protocol ldp
Cisco 10000 Series Router Software Configuration Guide
20-44
shows the configuration of Frame Relay over MPLS on two provider edge routers, PE1
20-7.
Frame Relay over MPLS Example Topology
pos4/0/0
CE1 PE1
ser7/0/0/1:0
Chapter 20
pos4/0/0
P
PE2
ser7/0/0/1:0
AToM vc_id =1
AToM vc_id =2
Configuring L2 Virtual Private Networks
CE2
ser8/0/0/1:0
(dlci=17)
(dlci=18)
OL-2226-23